6P1P-EV

Description

The output tetrode 6P1P-EV is used in the output single-cycle and push-pull circuits of low-frequency receivers and amplifiers. Designed to amplify low-frequency power in general-purpose radio-electronic equipment. Because of a different pinout (9-pin base versus 7-pin base) than an 6AQ5 / EL90, it cannot be used as a plug-in replacement for these types, however, it will work in the same circuit with component values unchanged, its maximum plate/screen voltage and dissipation ratings slightly higher than a 6AQ5.

Near equivalent tube: EL82, 6AQ5, EL90

E – characterizing the increased durability of the tube;
V – tube with increased reliability and mechanical strength.

• Stamp of technical control department of the manufacturer ” ОТК “

Technical specifications:

• Filament voltage: 6.3 ± 0.6V
• Filament current: 500 ± 40mA
• Anode voltage nominal (constant): 250V
• Anode voltage limit (constant): 250V
• Anode current: 44 ± 11mA
• Cathode current limit: 70mA
• Grid voltage of the first (constant): -12.5V
• The reverse current of the grid of the first is: not more than 1.0μA
• Grid voltage second nominal (constant): 250V
• Grid voltage second limit (constant): 250V
• Second grid current: no more than 7mA
• Power dissipated by the anode, limit: 12W
• Power dissipated by the second grid, limit: 2.5W
• The voltage between the cathode and the heater limit (constant): 100V
• Slope: 4.9 ± 1.1mA/V
• Internal resistance: 42.5 ± 22.5kOhm
• Output power: not less than 3.8W
• THD: 14%
• Resistance in the grid circuit of the first limit: 0.5MOhm

Operating time not less than 7500 hours.